HingeLab
← All help

Pop-up

Tips for the pop-up generator

The centre text, monogram, rim text and motifs can be scored instead of engraved (Engraving › Mark). Scored lines stop at the slots and openings, and in 3D they follow the formed rings or spiral.

  • The centre text, monogram, rim text and motifs can be scored instead of engraved (Engraving › Mark). Scored lines stop at the slots and openings, and in 3D they follow the formed rings or spiral.
  • Start with ring width at least 1.5 times stock thickness. Optional holding lands keep the blank together during cutting; remove them before fitting rigid supports. Acrylic and MDF are brittle.
  • Use profile ribs for repeatable support. Matched tabs and slots use measured thickness plus clearance. Cut a joint coupon first. Assemble supports, then lower rings in the numbered order in the Assembly guide, lowest seat first. L01 always identifies the outer rim.
  • Spiral and Multi show a continuous strip in its target form, with circular cuts inside any outline. Rigid ring joints are disabled automatically. Enable Spiral supports for a cuttable base, contoured ribs and retaining keys. Use the Assembly guide and test actual stock: the preview does not predict bending, springback or load capacity. Bevel depth uses gap / tan(angle). A standard perpendicular laser cannot make tilted cuts.
  • Use LED lights only, never candles or hot bulbs. Test loading before use as a stand or plant holder.