Key Holder
Tips for the key holder generator
No Weld (under Text, for Score and Raised): raised letters are cut as separate glyph pieces in the second material, and scored letters keep each glyph's own outline, so joined script still reads.
- No Weld (under Text, for Score and Raised): raised letters are cut as separate glyph pieces in the second material, and scored letters keep each glyph's own outline, so joined script still reads.
- Cut hooks from 4 to 6 mm plywood for heavy bunches; 3 mm hooks suit single keys.
- Glue each hook from the back with wood glue and let it set before hanging keys.
- Mark the keyhole spacing on the wall with a strip of masking tape laid over the board.
- Magnets: neodymium discs hold the steel key rings, not the keys; glue them flush with the front, as a magnet even 1 mm back holds much less.
- A mail pocket 40 to 60 mm deep and 50 to 70 mm high holds letters upright; keep the hooks below its bottom so keys do not hang in front of it.
- For a two-tone look, engrave the text on walnut-veneer plywood or use raised mirror acrylic letters.