HingeLab
← All help

QR Code

Tips for the qr code generator

On an engraved plate a plain label can be scored instead (Label mark); a bar label stays engraved, because its text is knocked out of the bar.

  • On an engraved plate a plain label can be scored instead (Label mark); a bar label stays engraved, because its text is knocked out of the bar.
  • Scan the screen before you cut: hold a phone up to the canvas; if it reads there, the plate will read too.
  • Contrast matters more than size: engrave dark and even, or use a black backplate under a light top plate. Two-colour acrylic (a light skin over a dark core) gives the sharpest engraved codes.
  • Keep modules at least 0.6 mm for engraving and 1.2 mm for cut-outs; a shorter web address makes fewer, larger modules.
  • A centre logo needs error correction Q or H, and keep it under about a fifth of the code's width.
  • Mask wood before engraving a code: it keeps the light modules clean of smoke, which phones read as dark.
  • For a counter sign, a 50 to 70 mm code reads from an arm's length; for a wall sign, make the code about a tenth of the distance people scan from.
  • With the Tap picture, stick an NFC tag behind it and write the same link to it, so phones can tap as well as scan.
  • For a stencil, spray light coats straight down and lift it straight up; the thin lines left by the bridges do not stop phones reading the code.