Laser cutting glossary
The words you meet when you laser cut and engrave, explained in a sentence or two.
- Kerf
- The width of material the laser burns away along a cut, usually 0.1–0.3 mm. Joints are offset by half the kerf so parts fit tight.
- Kerf compensation
- Moving each cut line outward or inward by half the kerf so the finished part comes out at its drawn size.
- Living hinge (kerf bending, flex cut)
- A pattern of short parallel cuts that lets a stiff sheet such as plywood or MDF bend round a curve.
- Finger joint (box joint)
- Interlocking rectangular tabs and slots along two edges that meet at a corner.
- Tab and slot
- A tab on one part that fits a matching slot in another, used to assemble flat-pack models without glue.
- Cut
- A vector line the laser follows at full depth to separate a part from the sheet.
- Score
- A vector line cut shallow, for fold lines and fine outlines that should not go through.
- Engrave (raster engraving)
- Filling an area line by line, like a printer, to mark a picture or text into the surface.
- Vector engraving (line engraving)
- Marking only along lines at low power, faster than raster engraving for outlines and text.
- Vector and raster
- Vector files describe lines and shapes (SVG, DXF, PDF) and are used for cutting; raster files are pixels (PNG, JPG) and are used for engraving.
- SVG
- Scalable Vector Graphics: the most common file for laser cutters and Cricut; keeps real sizes and colours.
- DXF
- Drawing Exchange Format from CAD software, read by almost every laser program.
- LightBurn (.lbrn2)
- The project file of LightBurn, a popular laser control program; it stores layers, speeds and powers.
- Layers (colour layers)
- Lines grouped by colour so the laser software runs each with its own speed and power: cut, score, engrave.
- Power and speed
- The main laser settings: more power or less speed burns deeper.
- Focus (focal length)
- The height at which the beam is narrowest; a sharp focus gives a thin kerf and clean edges.
- Air assist
- A jet of air at the cut that clears smoke and stops flames, for cleaner edges.
- Nesting
- Arranging parts close together on the sheet to waste less material.
- Bed size (work area)
- The largest sheet the laser can cut in one go, such as 400 × 400 mm or 600 × 400 mm.
- Material thickness
- The real thickness of your sheet. Slots and tabs must match it, and 3 mm plywood is often 2.7–3.2 mm.
- CO2 laser
- A laser tube at 10.6 µm that cuts wood, acrylic, leather and paper; brands include Glowforge, OMTech, Thunder and Epilog.
- Diode laser
- A smaller, cheaper laser module that cuts thin wood and engraves well; brands include xTool, Ortur, Atomstack and Creality Falcon.
- Fiber laser
- A laser for marking and engraving metal and some plastics.
- Dithering
- Turning a photo into dots (Floyd–Steinberg, Jarvis, Atkinson, halftone) so it can be engraved with on/off laser pulses.
- Bridges (tabs that hold)
- Small uncut gaps that keep the middle of a letter or stencil attached.
- Plywood, MDF and acrylic
- The most cut sheet materials: birch or poplar plywood, MDF fibreboard, and cast or extruded acrylic (PMMA).
- Shadow box (layered paper cut)
- Several cut layers stacked with spacers to make a 3D picture, often lit from behind as a light box.
- Book nook
- A small lit diorama that slides between books on a shelf.
More: kerf and fit tools · living hinge box generator · finger joint box generator · machines and software